Quest For Sound - High End Audio

iAMP amplifier was designed to provide a significant value based on a high performance to price ratio that will exceed the sonic quality of good solid state amplifiers with its musical accuracy.

Reference Series 2017 New Products

TIA-280R	TIA-260R	*TIA-240R*	*TPA-280*
Triode/Ultra Linear KT120 80W x 2	Triode/Ultra Linear KT88 60W x 2	Triode/Ultra Linear KT66 40W x 2	Triode/Ultra Linear KT150 100W x 2
Intergrated Amplifer	Intergrated Amplifier	Intergrated Amplifier	Power Amplifier

TIA series Intergrated Amplifier

TIA-216	TIA-280	TIA-260	TIA-240
Single Ended 300B 16W x 2	Triode / Ultra Linear KT120 80W x 2	Triode / Ultra Linear KT88 60W x 2	Push-Pull EL34 40W x 2

Features:

May be used as a passive pre-amplifier (fTIA series only)
Comprehensive manual supplied
Hand wired point to point
Class A Triode front end Output circuit
Ultralinear or Triode switchable for specified models
Wide Frequency Respnose / Low Distortion Tertiary custom output transformers (10Hz to 65KHz)
Exclusive "Closing Coupled Circuit" for our tailor-made output transformers
Built in Bias & tube test meter for specified models
3 potted transformers to reduce transformer noise
Japan ALPS Blue volume pot
Solen/SCR, M-Cap or Jensen Hi Fi quality audio capacitors
DCT3 silver plated power cord
DCT3 Pure Silver or Silver plated PTFE audio cable
Double silver plated, double rhodium plated DCT Input & speaker terminals
DCT input RCA terminals and output speaker cable terminals which are 4N OFHC with inner silver layer is 1.5 microns thickness and the outer rhodium layer is 0.5 microns thickness
DCT IEC power input
High technology soldering process with LEAD-FREE 2% SILVER SOLDER ensures consistency
CE ROHS

Deep Cryogenic Treatment DCT Tube
The process makes a permanent change and the benefits do not deteriorate over time or upon return to operating temperature, it changes the whole way the vacuum tube performs. The major benefit has been a dramatic improvement in dynamic range, micro detail with an increase in speed. Bass response has been clearer with a reduction in micro phonics. The proprietary DCT treatment process utilizes a computer controlled, cryogenic chamber to very gradually reduce the temperature of the tubes to 300 degrees below zero (Fahrenheit) and holding them there for a minimum of 24 hours. After the extended dwell at this cryogenic temperature, the vacuum tubes are then very slowly brought up to ambient temperature over the next 24 hours and stabilized. All these processes are microprocessor controlled under strict and verifiable conditions.