|
The Rose Gold Runwell Turntable, designed inside and out for the discriminating audiophile and easy to use by any music enthusiast. Featuring a built in phono preamplifier and a belt driven pulley with speeds of 33 1/3 rpm and 45rpm.
Wow and Flutter
< 0.1%
Gain
35.4DB @ 1KHZ
RIAA Conformance Deviation
LESS THAN +/- 0.25DB, 20HZ TO 20 KHZ, EXCLUSIVE OF INFRASONIC FILTER AT 13HZ
Input Overload
> 200MV AT 1KHZ
Input Impedance
47KOHM IN PARALLEL WITH 200PF
Signal-to-noise Ratio exclusive of cartridge intrinsic noise, unweighted
> 82DB
Gain 1kHz MM
35.4DB (JUMPERS OPEN)
Gain 1kHz MC
55.1DB (JUMPERS INSTALLED)
Termination impedance, MM gain resistive
47KOHM, VIA SYNTHETIC COOLED TERMINATION
Equivalent temperature of 47kohm input termination, midband
< 20 DEGREES KELVIN
Termination impedance, capacitive
200PF ON BOARD
Termination impedance, MC gain resistive
INSTALLED ON INPUT PADS PER CARTRIDGE REQUIREMENTS
EQ characteristic
RIAA STANDARD
Infrasonic filter
SECOND-ORDER MAXIMALLY-FLAT, -3DBR AT 13HZ
Line-level output resistance
49.9 OHMS, UNMATED
Overload margins
> 32DB AT ANY FREQUENCY FROM 20HZ TO 20KHZ, BASED ON REFERENCE LEVELS OF 5MV RMS AT 1KHZ, 500UV RMS AT 20HZ, 50MV RMS AT 20KHZ
Output noise, MM gain, at various analyzer filter bandwidths and 75 ohm generator Z
22HZ TO 22KHZ: 22UV RMS
100HZ TO 22KHZ: 12UV RMS
400HZ TO 22KHZ: 8.6UV RMS
Output noise, MC gain, 10 ohm generator Z
22HZ TO 22KHZ: < 220UV RMS
100HZ TO 22KHZ: < 120UV RMS
400HZ TO 22KHZ: < 86UV RMS
Power consumption from mains input, preamp only enabled
< 8W
Distortion at noise-versus-distortion inflection point
< 0.001%
Dimensions
18” X 13.875” X 7.5” (47.6CM X 35.2CM X 19CM)
Limited Lifetime Warranty
Every Shinola Runwell Turntable is guaranteed for life against manufacturing defects under the terms and conditions of our Limited Lifetime Warranty as described herein. Any defective component (excluding the cartridge, slipmat and belt) will be repaired or replaced by Shinola. If we cannot repair your turntable and the exact model is not available for replacement, a model of equal value will be provided. A copy of the receipt or your completed online product registration is required as proof of purchase. A check or money order payable to Shinola/Detroit, LLC in the amount of $50.00 will be required as a service and handling fee for all warranty services. This fee is subject to change.
THIS LIMITED WARRANTY DOES NOT COVER ANY DAMAGE OR OPERATIONAL FAILURE CAUSED BY:
Anything not within Shinola’s control. Specifically, this warranty shall not cover damage caused by improper handling, use or care on the part of the owner or any third party (other than any authorized Shinola sales or service personnel).
An accident of any kind, negligence, or any intentional act by the owner or any third party.
ADDITIONAL EXCLUSIONS; VOIDABILITY
This Limited Warranty shall not apply to or cover any damage to or failure of the cartridge (including stylus), slipmat or belt provided with this purchase. Further, this Limited Warranty shall not apply and shall be void with respect to (i) turntables with serial numbers (located on the platter and back plate) that have been defaced or altered or (ii) any repair, alteration, or modification made by persons other than Shinola personnel or a Shinola authorized dealer or service provider.
The Limited Warranty described herein is the sole and exclusive warranty for this product and is granted in lieu of any other warranty expressed, implied or statutory, including any warranty of merchantability or fitness for a particular purpose, each of which are expressly disclaimed by Shinola.
Shinola shall not be liable for incidental, consequential, indirect, special or punitive damages or liabilities of any kind arising out of or in connection with the sale or use of this product, whether based in contract, tort (including negligence), strict product liability or any other theory, even if Shinola has been advised of the possibility of such damages. Shinola’s entire liability shall be limited to replacement or repair at Shinola’s sole option.
REQUESTING WARRANTY AND OTHER REPAIRS
Should you require warranty service, please send your turntable, a copy of your sales receipt or proof of product registration and a completed repair form, which can be found on the Shinola website, to our service center listed below. Send your turntable in its original packaging to ensure your parcel is adequately protected during shipment. Shinola is not responsible for products lost or damaged during shipment to Shinola. You should adequately insure your shipment.
For service work that is not covered under this warranty, the service center may perform the services you request for a charge dependent on the type of work requested. You will be notified of such charges prior to Shinola commencing the requested repair(s). Shinola will commence such repairs only upon your prior approval to such charges.
In addition to the repair charges, if required, a service and handling fee of $50.00 will be charged for all repairs and warranty service. Such fee must be prepaid by check or money order payable to “Shinola/Detroit, LLC” at the time of delivery of the turntable to the repair center. This fee is subject to change.
Warranty & Repairs: Shinola/Detroit, LLC
485 W. Milwaukee St. Suite 501
Detroit, MI 48202
1-844-SHINOLA
SHINOLA STANDS BY OUR PRODUCTS AND TAKES YOUR PATRONAGE AS A PRIVILEGE.
In order to receive the maximum level of service, we ask you to please register your turntable by visiting www.shinola.com/audio-registration. While there is no penalty for not registering your turntable, proof of purchase is required for warranty service.
WE ARE HERE TO HELP YOU
If you have any concerns or questions, don’t hesitate to contact us. There are three ways to get in touch. Fill out the contact form on our website at shinola.com, give us a call or send us an email.
|
